Installation Steps

Check out our simple step-by-step installation.
It just doesn't get any easier than this! 

Before you start       

• Clean any dirt, dust and oils from your dashboard.
• Remove any vinyl protectant such as Armor All™ before installing your new Dashhugger®.

Ready, Set, Go

• Break-in your Dashhugger® by laying it out on your dashboard for 15 minutes where the sun will relax the material. 
• Crease the visible sew-lines so they contour to your dashboard. 
• Attach the loose Velcro® to the Velcro® tabs on your Dashhugger®. DO NOT REMOVE the plastic backing at this point.
• Align the defroster vents of your dashboard with the defroster vent openings on your Dashhugger®.
• Remove the first Velcro® tab (when properly aligned), and press firmly to your dashboard. Continue until all tabs have been firmly attached.

Troubleshooting

• If your defroster vents are covered up by your Dashhugger®, slip the Dashhugger® down into the groove between your windshield and your dashboard until they are properly aligned.

   

  Email us at Info@Dashhugger.Com

  To order by phone - Call us a 
  (8AM - 5PM PST except holidays)
  For Information - Call us at (559) 298-4529
  © Copyright 1998-2008 Dashhugger® of Clovis, California. All Rights Reserved.
  PO Box 933 Clovis,Ca